Markers, TS type

Handmade inscription.

Inscription durably protected with a transparent foil.

Application: For marking pipes, cables and wires in switchgears or electrical and industrial systems, etc.

Working temperature: -30÷+70 °C.

Features:

1. The inscriptions are handmade by means of a pen or laser printer can be used.

2. They have a form of transparent, self-adhesive PVC foil, dimensioned A x L, with an overprinted white description field on one end dimensioned A x B.

3. At mounting, the inscription is covered with a transparent foil which protects it against destruction and at the same time does not decrease its readability

4. The marker can be wrapped around the wire or formed into a flag – recommended particularly where there is little room.

Advantages:

1. Inscriptions can be formed at choice.

2. A great variety of sizes enables any marking required.

3. Easy mounting, high quality and durability of inscriptions.

4. Very low cost.

5. The markers are resistant to typical solvents (excepting alcohol), grease, oil, etc., sea water, mould, rotting and atmospheric conditions.

Mounting method:

1. The cable to be marked should be cleaned from soil and dust.

2. Stick the marker onto a cleaned place as shown below or form a flag.

Packing: small notebook or A4 sheet.

Markers for handwrinting, TS type

Markers for phase colour-marking, type TS

Colored whole surface of marker

Colour code:
Y – yellow; 
YG – green-yellow; 
G – green; 
N – blue; 
F – violet.

Note!
Another colour - on request.